Products on www.Shieldlab.com


Alarm Monitoring

Alarm Monitoring

PPC Ad

Trustpilot Badge >

Women's Self Defense

Women's Self Defense

Members Online

129 Guests, 0 Users

Author Topic: Moose Z1000 System 1 panel wiring  (Read 2174 times)

hookcapn

  • Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Moose Z1000 System 1 panel wiring
« on: September 18, 2012, 03:12:36 PM »
Z1100 System I
When system had smoke detector problem (alarm continually sounding), some wires and fuse were disconnected.   Since then all smoke detectors were replaced with updated replacements. Wires were foolishly not marked as to terminals they were attached. Now wires need to be reconnected.  I have two reds to connect to terminal #24 and one black to terminal# 28. I have one wire (black) that goes from terminal #31 outside the cabinet to a resistor, marked [CP10 Mexico 10W   1 ohm 10% Dale 9722] a wire (white) then goes inside the cabinet. It is this wire I have doubts as to where to connect it.  Any enlightenment appreciated.
I am obviously not an electrician, just a handy guy.

 

Powered by EzPortal