Products on www.Shieldlab.com


Alarm Monitoring

Alarm Monitoring

PPC Ad

Trustpilot Badge >

Women's Self Defense

Women's Self Defense

Members Online

149 Guests, 0 Users

Author Topic: NX-8E No Interior Zones Work ?  (Read 1293 times)

increa

  • Member
  • *
  • Posts: 6
  • Karma: +0/-0
    • View Profile
NX-8E No Interior Zones Work ?
« on: October 20, 2016, 12:20:33 PM »
When I arm with STAY, it works as expected.  However, when I arm with EXIT, it behaves like STAY.  Also, if I arm with my pin# and don't exit, it goes into STAY mode, with internals bypassed (as expected).  However, if I ~do~ open a designated exit door and then close it, the system arms and will not respond to internal zones (just like STAY mode). 

I know I must have one of the several hundred programming locations wrong.  I'm still learning what they each do.  I installed an NX-8E (replacing a lightening struck NX-8V2) and hand programmed everything through a keypad.

Now, it all seems to work like the NX-8V2 did exempt my interior zones don't alarm.  Voltages are good at the terminals, which are double-zoned, so I can see low, medium, and high voltages.  I know the hardware is good.  When I individually move the alarm switches in an un-armed state, I can see the status of the zones change on the keypad display. 

Any idea of what I have programmed wrong?


bramfrank

  • Security Guru
  • ****
  • Posts: 682
  • Karma: +10/-1
    • View Profile
Re: NX-8E No Interior Zones Work ?
« Reply #1 on: October 27, 2016, 06:13:44 AM »
If you read the entire thread about the person who was trying to re-use the NX6 you will discover the answer to your question, since his issue was exactly the same:

Turn off the parameters that enable automatic home/away.
Able1 is a twit.  Correction, Twit is too mild a term.

Musseknun

  • Member
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Re: NX-8E No Interior Zones Work ?
« Reply #2 on: October 23, 2017, 04:21:02 AM »
I like this way of thinking is very high.



แทงบอล sbobet
« Last Edit: March 26, 2018, 11:57:23 PM by Musseknun »

AndrewBradd

  • Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: NX-8E No Interior Zones Work ?
« Reply #3 on: October 25, 2017, 12:01:34 AM »
Can I use it? If it works, I will try to do it.

 

Powered by EzPortal