Products on www.Shieldlab.com


Alarm Monitoring

Alarm Monitoring

PPC Ad

Trustpilot Badge >

Women's Self Defense

Women's Self Defense

Members Online

110 Guests, 0 Users

Author Topic: 128 BPT Fire with verify programming  (Read 203 times)

jc30120

  • Member
  • *
  • Posts: 4
  • Karma: +0/-0
    • View Profile
128 BPT Fire with verify programming
« on: May 17, 2017, 03:39:56 PM »
I am using Compass 2.0 with a Vista 128-BPT.

My difficulty is with the 4-wire smoke detectors and specifically programming the relay that interrupts the 12v supply to the detectors when an alarm is first detected.
My understanding was that at the first fault the relay would fire for a few seconds opening the normally closed contact then return 12v to the detectors. Any further fault would trigger an alarm.
It would seem that only a Start Zone type #54 would be needed.

There are START TYPES, STOP TYPES, and ACTIONS. I have tried various combinations but nothing works as I think it should.
The only settings that are halfway suitable are ACTION 'close for 2 sec" and START TYPE 54-Fire Reset.

Any help greatly appreciated

 

Powered by EzPortal